1000 series mini converter – Signamax 10/100BaseT/TX To 100BaseFX Mini Converters User Manual
Page 2

065-1000 series Mini Converter
2
Installation
This chapter gives step-by-step installation instructions for the Converter.
Selecting a Site for the Equipment
As with any electric device, you should place the equipment where it will not be subjected to extreme temperatures, humidity, or
electromagnetic interference. Specifically, the site you select should meet the following requirements:
•
The ambient temperature should be between 32 to 122 degrees Fahrenheit (0 to 50 degrees Celsius).
•
The relative humidity should be less than 90 percent, non-condensing.
•
Surrounding electrical devices should not exceed the electromagnetic field (RFC) standards for IEC 801-3, Level 2 (3V/M) field
strength.
•
Make sure that the equipment receives adequate ventilation. Do not block the ventilation holes of the equipment.
•
The power outlet should be within 6 feet (1.8 meters) of the product.
Connecting to Power
This Converter is a plug-and-play device.
Connect the supplied AC to DC power adaptor to the receptacle on the rear panel of the converter, and then attach the plug into a
standard AC outlet with a voltage range from 100 to 240VAC.
Specifications:
Applicable Standards
IEEE 802.3 10BaseT
IEEE 802.3u 100BaseTX & 100BaseFX
Fixed Ports
1 TX port, 1 FX port
10 Mbps for half/full-duplex
Speed: 10BaseT
100BaseTX/FX
100 Mbps for half/full-duplex
Switching Method
Store-and-Forward
Forwarding rate
14,880 / 148,800 pps for 10/100 Mbps
LED Indicators
Per Unit- (2 LEDs): TX LNK/ACT; FX LNK/ACT
Dimensions
2.15 × 3.16 × 0.87 in. W x D x H (54.6 × 80.3 × 22.1 mm)
Weight
5 ounces (0.14 kg)
Power
External power adaptor 12 Volts DC, 0.8 Amp
Power Consumption
9.6 Watts Max.
Operating Temperature
32°F ~ 122°F (0°C ~ 50°C)
Storage Temperature
-13°F ~ 158°F (-25°C ~ 70°C)
Humidity
10 ~ 90%, non-condensing
Emissions
FCC part 15 Class A, CE Mark