Loading default setup, Checking system information, Click info, the window below will appear – Q-See QSTD2408 User Manual
Page 43: 3 loading default setup, 4 checking system information
QSTD2400 Series DVR User’s Manual
Notice: If a “no device” or “no file” error appears, it is possible that the USB device is
incompatible. Please try another USB flash drive.
Please be patient. It will take 2-3 minutes to update.
The DVR has different setup blocks, like Basic, Record, Schedule, Motion etc.
Users can choose any block to restore default setup, see Fig 5.2 Reset Blocks.
Fig 5.2 Reset Blocks
STEP1
Enter TOOLS configuration, refer to 4.2.10 Tools Configuration.
STEP2
Click Load default. Select setup blocks; please refer to Fig 5.2 Reset
Blocks.
STEP3
Press OK to reset to default. It will return to TOOLS interface when
finished.
5.4 Checking System Information
To check system information like firmware version, IP address, etc.
STEP1
Press right mouse button to show the control bar. Click Menu, refer
to Fig 4.2 Pop up Menu.
STEP2
Click Info, the window below will appear.
Fig 5.3 Status Interface
STEP3
Click System, the window below will display. Check firmware version,
39