Proceed PDP - Manual (Page 7)

7
Set-up and installation
To set up your Proceed PDP 3, you’ll need:
■ A soft cloth or towel (step 2)
■ A high-quality audio cable for each digital source you intend to
connect to the PDP 3 (step 6)
■ A pair of high-quality audio cables for connecting the PDP 3 to
your receiver, integrated amplifier, or preamplifier (step 7)
■ A high-quality audio cable for connecting the PDP 3's digital
output to another digital processor (optional; step 8)
1. Make sure that the PDP 3 is unplugged from the AC power supply
and disconnected from your receiver, integrated amplifier, or
preamplifier.
2. Place the PDP 3 upright on a flat, stable surface. Carefully tip it so it
rests on its top; protect its finish with a soft cloth.
3. The PDP 3 is shipped so that it rests solidly on two wide “feet,”
positioned under the front and back of the unit.
You may want to explore the potential sonic advantages of
installing the specially designed “spikes” supplied with the unit.
One arrangement is to install the spikes under the corners of the
unit:
Four spikes,
mounted at the corners
Installing the spikes
(optional)