Proceed PDP - Manual (Page 13)

13
Troubleshooting
In general, service problems with your PDP 3 should be referred to your
Proceed dealer. Before contacting your dealer, however, check to
see if the problem is listed here. If it is, try the suggested solutions. If
none of these solves the problem, contact your Proceed dealer.
1. The PDP 3 won’t function, and the display is dark.
■ The master power switch on the rear panel isn’t turned on.
NEVER operate the master power switch without first making
sure that power is turned off to your receiver, integrated
amplifier, or preamplifier/power amplifier.
■ The PDP 3 is in standby mode (check to see if the standby LED
is lighted; see “Front panel”). To take the PDP 3 out of standby,
press the standby button on the front panel.
■ The PDP 3 isn’t plugged into the power supply (either a wall
socket or a convenience outlet on your receiver, integrated
amplifier, or preamplifier).
■ The wall socket, adapter, extension cord, or convenience
outlet is faulty. Check all connections.
■ There’s a tripped circuit breaker or blown fuse in the wall
outlet’s circuit.
■ The PDP 3’s fuse is blown (contact your Proceed dealer).
2. No sound comes out of the speakers or headphones.
■ The proper source isn’t selected on the PDP 3.
■ The proper input isn’t selected on your receiver, integrated
amplifier, or preamplifier.
■ The audio cables are connected incorrectly.
PRECAUTION