Paxton Superchargers 4.7 Dodge Ram User Manual

Page 13

Text mode
Original mode

3-5

P/N: 4809641a

01MAY06 v1.1 Dodge Ram 1500(4809641av1.1)

Fig. 3.3-f

Tighten the nut on the tensioner pulley using a
3/4" wrench. You will have to bend the upper-
most a/c line up slightly to clear the belt.

(See

Fig. 3.3-g.)

Also, bend it up slightly at the radi-

ator end until it clears. (Your air conditioner lines
may differ from the picture and some steps may
not be needed.)

Fig. 3.3-g

TENSIONER

NUT

Fig. 3.3-e

Fig. 3.3-h

Install the supplied longer accessory drive
belt. Use the factory belt routing with the
exception of going around the supplied idler
and S/C drive pulley. (See Fig. 3.3-e.)

Tighten the supercharger drive belt and ten-
sioner by turning the leadscrew clockwise
using a 10mm socket. The belt should be
very tight as it will stretch after being run.
(See Fig. 3.3-f)

Reinstall the factory fan and clutch assem-
bly.