Paxton Superchargers 4.7 Dodge Ram - Manual (Page 10)

3-2
P/N: 4809641a
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
01MAY06 v1.1 Dodge Ram 1500(4809641a v1.1)
Fig.3.2-d
F. Install the new Accessory drive belt. (See
Fig.3.2-e.) Re-install the fan. (See Fig.
3.2-f.)
Fig. 3.2-b
D. Bolt the A/C compressor back in place using
the original hardware. You may need to bend
the A/C line slightly to fit in corner of plate.
(See Fig. 3.2-c.)
Fig. 3.2-c
A/C COMPRESSOR
A/C LINE
FITTING TO
BE TRIMMED
E. Bolt the front plate to the rear plate using a
9/16", 3/4" and a 17mm socket (See Fig.
3.2-d.) See Appendix “C”. Check the tight-
ness of the small idler attached to the plate
with a 9/16" socket.
C. Trim the plastic hose that connects to the oil
filler by cutting it off just before the second
barb (approx 3/4"). Do not remove the sec-
ond barb as this keeps the hose from coming
off under boost. (See Fig. 3.2-c.) Install the
supplied longer hose. The oil fill will be
reinstalled at a later stage of the installation.
A. Attach the rear support plate to the cylinder
head using the supplied large bolt. (See Fig.
3.2-a.) Use at least two of the supplied 6mm
bolts to align the bracket with the other
mounting holes before tightening. Make sure
the supplied O-ring is in place on the rear of
the plate.
Fig. 3.2-a
B Bolt the oil filler neck to the plate using the
supplied hardware. (See Fig. 3.2-b.) Re-
attach the PCV hose.
3.2 SUPERCHARGER MOUNTING
BRACKET INSTALLATION