Icro unit installation – OT Systems FTD110DBMicro User Manual
Page 7
FT110DBMicro Series Installation & Operation Manual
7
3.2 Micro unit installation
a)
Mount the clip (Fig. 3.2) onto a fixture, e.g. a plank, (either on the wall or on a flat surface)
with two screws through the holes on the mounting frame to secure it in position.
(a) Front view
(b) Side view
Fig. 3.2
Micro unit’s clip
b)
The provided power supply should also be mounted on the same fixture or in the proximity
for connection of the supply cables to the unit, provided that an AC power supply socket is nearby
for powering the adaptor.
c)
Push the Micro unit into the clip to secure it in position. For details, please follow Fig. 3.3.
(a) Installation (b) Side view of the clip
(c) Side view of the Micro unit pushed into the clip
Fig. 3.3 Micro unit installation on the clip
d)
Connect all the signal inputs and outputs at the back of the unit with appropriate cables: fiber
optic cable for optical link and UTP cable for data input/output (Tx/Rx).
e)
Once the unit is powered up, check that the red POWER LED on the unit is lit. If not, check
the power supply cable connections between the unit and the power supply socket.
f)
With all the signals available at the input and output ports, check the status of LEDs located
on the unit. With correct status of each LED, installation is now completed [for LEDs status, see
Operational Guides
on this manual’s section (5)].