Oklahoma Sound #22 - Manual (Page 3)

aSSemBly inStRuCtionS
assembly tips
• Do not use a sharp instrument such as a knife or screwdriver to
open the packaging, as this may scratch or damage the unit
• All assembly should be done on a clean protected surface
such as carpet or the like.
• Make sure that you have all the required parts. (A list of all
the parts is listed below.)
• Read the instructions carefully and follow the diagrams to
ensure an easy and correct assembly.
tools Required
#2 Phillips Head Screwdriver
Hammer
parts
12 Cams...............
12 Cam Bolts ..............................
4 Platic Glides .........
1 Front Panel
1 Right Panel
1 Left Panel
1 Bottom (Shelf Panel)
Reading Surface
(can be identified by bookstop
which is already installed)
example of Cam lock assembly
3) Now connect the left side Panel C to the semi assembled unit.
Be sure to align the cam bolts to the holes on both the front
panel and the bottom panel. Then once agian tighten cams as
in step 1 (Diagram D)
Diagram "E"
4) Stand the lectern up. Taking Panel D the reading surface
of the lectern with the 4 installed cam-bolts facing down
(the book stopper will be facing up), align bolts with
holes on the top edges. Once they are in place apply
gentle pressure on the reading surface until it lies flat on
all of the top edges, then tighten cams (Diagram E).
O
klahOma
S
Ound
C
OrpOratiOn TABLE TOP LECTERN: Model 22
Diagram "D"
6 3