Oklahoma Sound #LSS - Manual (Page 7)

7
Step 11:
a) Proceed to aƩach the leŌ side panel #E to
the other side of rear panel #F and panel
#H by aligning the cam bolts on panel #E
with the cam lock holes on the side of pan-
el #F.
b) The wooden dowels on the edge of panel
# F should align with the predrilled holes
on panel #E.
c) Be sure to align the predrilled hole on the
edge of the surface panel #H with the pin
on panel #E as shown.
d) Once everything is aligned proceed to gen-
tly insert the cam bolts onto the holes unƟl
all the panels are completely flush.
e) Proceed by turning the cam bolts using
a Phillips screwdriver to lock all the
panels together.
Step 12:
a) Insert five cam bolts #5 into the plasƟc
inserts on the surface of panel #D as
shown. Use a Phillips screwdriver to
install the cam bolts properly.
Step 13:
a) Begin by liŌing the surface panel #H all
the way open as shown.
b) LiŌ the cabinet over panel #D to align
the five cam lock holes at the boƩom of
panels #E, #F and #G with the five cam
bolts on panel #D. (Two on panels #E
and #G and one on panel #F)
c) Once aligned gently lower the cabinet
over the cam bolts so the cabinet walls
are flush with the base panel #D as
shown.
d) Proceed by turning the cam locks
using a Phillips screwdriver to lock
the cabinet walls and the cabinet
base together.
e) Pull the laptop shelf panel #D all the
way open to access all the cam locks.
STEP 12
STEP 13
STEP 11