NEXCOM DNA 1150 - Manual (Page 48)

Copyright © 2013 NEXCOM International Co., Ltd. All Rights Reserved. 34 DNA 1150 User Manual
Chapter 4: BIOS Setup
Super IO Configuration
This section is used to configure the serial ports.
Super IO Chip
Displays the Super I/O chip used on the board.
Serial Port 1 Configuration
Configures the IO/IRQ settings of serial port 1.
Restore AC Power Loss
Select AC power state when power is re-applied after a power failure.
Advanced
Version 2.16.1242. Copyright (C) 2013 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2013 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Set Parameters of Serial Port
O (COMA)
NCT6776 Super IO Configuration
Super IO Chip
Serial Port 1 Configuration
Power Supply Type
Restore AC Power Loss
NCT6776
ATX
[Last State]
Serial Port 1 Configuration
This section is used to configure serial port 1.
Serial Port
Enables or disables the serial port.
Change Settings
Selects an optimal setting for the Super IO device.
Advanced
Version 2.16.1242. Copyright (C) 2013 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2013 America Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Enable or Disable Serial Port
(COM) Serial Port 1 Configuration
Serial Port
Device Settings
Change Settings
[Enabled]
IO=3E8h; IRQ=7;
[Auto]
