beautypg.com

NEXCOM NISE 105 User Manual

Page 68

background image

Copyright © 2013 NEXCOM International Co., Ltd. All Rights Reserved.

55

NISE 105/105A User Manual

Chapter 4: BIOS Setup

IDE Configuration

This section is used to configure the SATA drives.

Advanced

Version 2.16.1242. Copyright (C) 2013 American Megatrends, Inc.

Aptio Setup Utility - Copyright (C) 2013 American Megatrends, Inc.

→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit

Enable or disable SATA Device.

IDE Configuration

Serial-ATA (SATA)

SATA Speed Support

SATA Mode

Serial-ATA Port 0

SATA Port0 HotPlug

Serial-ATA Port 1

SATA Port1 HotPlug

SATA Port0

ST320LT012-9WS (320.0GB)

SATA Port1

Not Present

[Enabled]

[Gen2]

[AHCI Mode]

[Enabled]

[Disabled]

[Enabled]

[Disabled]

Serial-ATA (SATA)
Enables or disables SATA device.

SATA Speed Support
Configures the SATA controller to Gen1 or Gen2 speed.

SATA Mode
Configures the SATA as IDE, AHCI or RAID mode.

SATA Mode
Configures the SATA as IDE, AHCI or RAID mode.

IDE

This option configures the Serial ATA drives as Parallel ATA

physical storage device.

AHCI

This option configures the Serial ATA drives to use AHCI

(Advanced Host Controller Interface). AHCI allows the storage

driver to enable the advanced Serial ATA features which will

increase storage performance.

Serial-ATA Port 0 and Serial-ATA Port 1
Enables or disables SATA port 0 and SATA port 1.

SATA Port1 Hotplug and SATA Port2 Hotplug
Enables or disables hotplug support on SATA port 1 and SATA port 2.

This manual is related to the following products: