NEXCOM NISE 104 - Manual (Page 72)

Copyright © 2012 NEXCOM International Co., Ltd. All Rights Reserved. 58 NISE 104 User Manual
Chapter 4: BIOS Setup
Interrupt 19 Capture
When enabled, it allows the optional ROM to trap interrupt 19.
Boot Option Priorities
Boot option #1
Security
Save & Exit Advanced Chipset Boot Security Main
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2011 America Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Select AC power state
whenpower is re-applied
after a power failure.
Boot configuration
Setup Prompt Timeout
Bootup NumLock State
Quiet Boot
CSM16 Module Version
GateA20 Active
Option ROM Messages
Interrupt 19 Capture
Boot Option Priorities
Boot Option #1
Boot Option #2
Hard Drive BBS Priorities
Boot Option #1
SATA SM:TS4GCFX500I
Disabled
UEFI: -Pretec 01GB 2.00
1
[On]
[Disabied]
07.65
[Upon Reauest]
[Force BIOS]
This field is used to adjust the boot sequence of the system. Boot Option #1
is the first boot device that the system will boot from, next will be #2 and
so forth. User Password
Sets the user’s password.
Administrator Password
Sets the administrator’s password
Save & Exit Advanced Chipset Boot Security Main
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2011 America Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Set Administrator
Password
Password Description
If ONLY the Administrator’s password is set, then this
only limits access to Setup and is only asked for when
entering Setup.
If ONLY the User’s password and must be entered
to boot or enter Serup. In Setup the User will have
Administrator rights.
The password length must be
in the following range:
Minimum length 3
Maximum length 20
Administrator Password
User Password