beautypg.com

Configure sata as sata controller(s), Usb configuration – NEXCOM NISE 104 User Manual

Page 63

background image

Copyright © 2012 NEXCOM International Co., Ltd. All Rights Reserved.

49

NISE 104 User Manual

Chapter 4: BIOS Setup

Configure SATA as

SATA Controller(s)

Enables or disables SATA controller.

USB Configuration

This section is used to configure USB devices.

Configures the SATA as IDE or AHCI mode.

IDE

AHCI

This option configures the Serial ATA drives as Parallel ATA physical
storage device.
This option configures the Serial ATA drives to use AHCI (Advanced
Host Controller Interface). AHCI allows the storage driver to enable
the advanced Serial ATA features which will increase storage
performance.

Advanced

Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.

Aptio Setup Utility - Copyright (C) 2011 America Megatrends, Inc.

→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit

Select a configuraton for SATS
Controller

SATA Port0

SATA Port1

SATA Controller(s)

Configur SATA as

Not Present

Not Present

[Enabled]

[AHCI]

Configure SATA as

IDE

AHCI

Save & Exit

Advanced

Chipset

Boot

Security

Main

Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.

Aptio Setup Utility - Copyright (C) 2011 America Megatrends, Inc.

→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit

USB Configuration Parameters

Legacy OpROM Support

Launch Lan1 PXE OpROM

Launch Lan2 PXE OpROM

CPU Configuration

IDE Configuration

USB Configuration

Super IO Configuration

H/W Monitor

PPM Configuration

[Disabled]

[Disabled]