NEXCOM EBC 355 - Manual (Page 54)

Copyright © 2014 NEXCOM International Co., Ltd. All Rights Reserved. 40 EBC 355 User Manual
Chapter 3: BIOS Setup
Configure SATA As
Configures the SATA as IDE, AHCI or RAID mode.
IDE This option configures the Serial ATA drives as Parallel ATA
physical storage device.
RAID This option allows you to create RAID or Intel Matrix Storage
configuration on Serial ATA devices.
AHCI This option configures the Serial ATA drives to use AHCI
(Advanced Host Controller Interface). AHCI allows the storage
driver to enable the advanced Serial ATA features which will
increase storage performance.
Serial-ATA Port 0 and Serial-ATA Port 1
Enables or disables SATA port 0 and SATA port 1.
SATA Port1 Hotplug and SATA Port2 Hotplug
Enables or disables hotplug support on SATA port 1 and SATA port 2.
Serial-ATA (SATA)
Enables or disables the SATA device.
SATA Speed Support
Configures the SATA controller to Gen1 or Gen2 speed.
IDE Configuration
This section is used to configure the SATA drives.
Advanced
Version 2.16.1242. Copyright (C) 2013 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2013 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Enable / Disable Serial ATA IDE Configuration
Serial-ATA (SATA)
SATA Speed Support
SATA Mode
Serial-ATA Port 0
SATA Port0 HotPlug
Serial-ATA Port 1
SATA Port1 HotPlug
SATA Port0
Not Present
SATA Port1
Not Present
[Enabled]
[Gen2]
[AHCI Mode]
[Enabled]
[Disabled]
[Enabled]
[Disabled]