Monroe Electronics R176 - Manual (Page 2)

Operation
The R176’s primary PRI inputs
are normally connected to the
common COM outputs. It
remains in this state until the Set
input is connected to GND, or the
DTMF (Cue Tone) ON command is
received, and a baseband video
signal of at least 0 dB is present.
The unit will switch during the
vertical blanking interval of the
video signal. This connects the
secondary input to common until
Set is not connected to GND, or
until the DTMF (Cue Tone) OFF
command is received.
Specifications
(firmware 80177-3.00)
DTMF Input Levels
-20 to +3 dB
Video
75 ohms ; ‘BNC’ connectors
Audio
Balanced stereo; screw terminals;
>90 dB isolation
Isolation
@ 5 MHz > 80 dB
Control Input
1 mA maximum to GND.
Power Requirement
117VAC ±10%, 60 Hz.
Power pack output; 13.6 VAC
Physical
1.75"H x 19"W x 4"D
Weight 2 lbs.
Design and specifications are subject to change
without notice.
Warranty
Monroe Electronics, Inc. warrants to the owners, each instrument and sub-
assembly manufactured by them to be free from defects in material and
workmanship for a period of one year after shipment from factory. This
warranty is applicable to the original purchaser only.
Liability under this warranty is limited to service, adjustment or replacement
of defective parts (other than fuses or batteries) on any instrument or sub-
assembly returned to the factory for this purpose, transportation charges
prepaid.
This warranty does not apply to instruments or sub-assemblies subjected to
abuse, abnormal operating conditions, or unauthorized repair or modification.
Since Monroe Electronics, Inc. has no control over conditions of use; no
warranty is made, or implied as to the suitability of our product for the
customer's intended use.
THE WARRANTY SET FORTH IN THIS ARTICLE IS EXCLUSIVE AND IN
LIEU OF ALL OTHER WARRANTIES AND REPRESENTATIONS,
EXPRESSED, IMPLIED OR STATUTORY INCLUDING, BUT NOT LIMITED
TO THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS.
Except for obligations expressly undertaken by Monroe Electronics, in this
warranty, Owner hereby waives and releases all rights, claims and remedies
with respect to any and all warranties, express, implied or statutory (including
without limitation, the implied warranties of merchantability and fitness), and
including but without being limited to any obligation of Monroe Electronics with
respect to incidental or consequential damages, or damages for loss of use.
No agreement or understanding varying or extending the warranty will be
binding upon Monroe Electronics unless in writing signed by a duly authorized
representative of Monroe Electronics.
In the event of a breach of the foregoing warranty, the liability of Monroe
Electronics shall be limited to repairing or replacing the non-conforming goods
and/or defective work, and in accordance with the foregoing; Monroe
Electronics shall not be liable for any other damages, either direct or
consequential.
Return Policy
Materials returned to Monroe must have a Return Material Authorization
number. To obtain a RMA number, contact our A/V Switching & Control
Customer Service at 585-765-2254 or fax 585-765-9330. Customers have 30
days to determine that the product ordered fills their need and performs as
described in Monroe’s literature. Units returned for approved repair or credit,
must be in the original packaging including all parts and paperwork plus be in
very good physical condition. If not, the customer is billed the cost to refurbish
the unit and for missing accessories and merchandise. No products may be
returned for exchange or credit after 12 months of the shipment date. Monroe
reserves the right to repair or replace units under warranty.
P/N 1340189 7/24/02 Rev A