KLING & FREITAG K&F SONA SUB - Manual (Page 10)

User's manual K&F SONA SUB
KLING & FREITAG GMBH © 2014 Version 2.1 Page 10 of 21
Remove the grille:
Push one side of the grille towards the
middle of the speaker (1).
Keep pushing the side and, while doing
so, slide the side of the grille upwards out
of the fastening groove (2).
Now slide the other side of the grille
towards the middle of the speaker (1).
Remove the grille by pulling it upwards
out of the fastening groove. (2).
Turn the screws for the keyhole mounting
points into the wall.
~ 6 - 7 mm
Remove the stopper in the fixing hole (1).
Connect the speaker cables. Follow the
instructions in chapter Wiring beginning
on page 16.
At the keyhole mounting points, hang the
speaker onto the screws (2) .
Fixate the speaker with the fixing screw
(3).
During use, the fixing bore must be
closed by a fixing screw. If not, strong
interference may occur.