Instruction of disassembly – KBC Networks 3U Chassis Transceiver User Manual
Page 38
Manual-FD＿BSeries-Rev1008.pdf Page 34 of 34
Copyright © KBC Networks Ltd.
10. Instruction of Disassembly
Instruction of Disassembly of KBC Product
(For EU Directive 2002/95/EEC━WEEE)
Tools Required:
1) 5 mm flat tip screwdriver
2)
Φ3 cross tip screwdriver
3)
Φ5 cross tip screwdriver
4) Size small snip nose pliers
5) 15 mm spanner
Steps for Disassembly:
1) Remove tightening screws of box cover (1 or 4-8 screws in general).
2) Remove lock nut for BNC with spanner.
3) Remove cover plate.
4) Remove tightening screws for printed circuit board (PCB).
5) In case the assembly has more than one PCB then continue removing the remain
tightening screws until none left.
6) Use snip nose pliers to loose the nut of flange and then remove optic cable
connector (jump wire).
7) Snip off power conducting cable and remove power switch /jack/etc..
8) Take out all PCBs.
9) Disassembly of product completed.
Notice：When a product reaches the end of it
’s life—return to KBC