beautypg.com

Quick start guide, Enc-a-w, Encoder – KBC Networks MPEG-4 Encoder User Manual

Page 2

background image

Note:

Other configuration changes can be

saved without following
each individual change. However, after the
WAN settings are changed, the unit must
be rebooted. The interface can then be
accessed on the new IP address. If the
subnet of the encoder WAN setting has
changed, verify that the computer’s static
IP is changed to match the subnet of the
new IP address. If the IP address is
changed, the decoder Setting> TCP/IP Connect IP must reflect
the new encoder IP address.

6.

Select:

7.

Only if desired, Select: to
change default User ID and/or password
Select: ; insert new ID and/or
password at web browser prompt

Select:

Note:

If a change is made to the encoder GUI

User ID and/or password the same
changes must be recorded in the decoder’s
TCP/IP Connect
User ID and Password.

LED Status

Description

PWR

ON

Power supplied to the unit
(allow 30 secs to settle)

OFF

No power to the unit

RX

FLASH Camera sending

communication to encoder

OFF

Normal conditions

TX

ON

PTZ control signals being
sent from decoder

OFF

Normal conditions

Ethernet RJ45 Port Status LED

Each RJ45 Ethernet port has 2 indicators, a yellow
lamp & a green lamp. The yellow lamp indicates video
is streaming, the green lamp indicates port link state.

Link Status
(Green)

ON

Link connected

OFF

No connection

LINK/ACT
(Yellow)

FLASH Streaming video


Note:

A solid RX LED indicates a data wiring or

other data related error.


Dip Switch Default Configuration

RS485/422 RS232

1 to 4 - ON 1 to 4 - OFF
5 to 8 - OFF 5 to 8 - ON

PTZ Data Wiring Configuration

RS-485, 2 wire: Camera RX to encoder TX+

Camera RX- to encoder TX-

RS-422, 4 wire: Camera TX+/- to encoder TX+/-

Camera RX+/- to encoder RX+/-

RS-232: transmit to encoder TX+
receive to encoder RX+
ground to encoder GND

Contact Closure Default Configuration

ENC-A-W* Encoder

Action

DEC-A-W* Decoder

D01 DO2 DI1

DI2

D01 D02 DI1

DI2

ON ON

ON

ON

Normal state

OFF OFF ON

ON

OFF ON

ON

ON

Short decoder DI1
to gnd

GND

ON OFF ON

ON

Short decoder DI2
to gnd

GND

GND

Short encoder DI1
to gnd

ON

OFF ON

ON

GND Short encoder DI2

to gnd

OFF ON

ON

ON

Note:

Triggers from default configurations shown. See

decoder interface settings to configure other trigger
options.

Need Help/Troubleshooting?

Visit our website

http://www.kbcnetworks.com

or

contact your nearest KBC office or dealer:

APAC:
Phone: +65 98463323
Email:

[email protected]


EMEA:
Phone: +44(0)1622 618787
Email:

[email protected]


USA:
Phone: +1 949-297-4930

Toll Free: +1 888-366-4276

Email:

[email protected]

Quick Start Guide

ENC-A-W*

Encoder

Encoder Status Indicators

QSG_Encoder_MPEG4-Rev1206

www.kbcnetworks.com

Copyright © KBC Networks Ltd. 2012