Quick start guide, Dec-a-w, Decoder – KBC Networks MPEG-4 Decoder User Manual
Page 2
Note:
Other configuration changes can be
saved without
each individual change. However, after the
WAN settings are changed, the unit must
be rebooted. The interface can then be
accessed on the new IP address. If the
subnet of the decoder WAN setting has
changed, verify that the computer’s static
IP is changed to match the subnet of the
new IP address.
6.
If the encoder default settings were
changed, Select:
and make appropriate changes to reflect
the new encoder settings.
Select:
Select:
7.
Select:
rate for the PTZ control
Select:
Select:
Select:
8.
Only if desired, Select:
change default User ID and/or password
Select:
password at web browser prompt
Select:
LED Status
Description
PWR
ON
Power supplied to the unit
(allow 30 secs to settle)
OFF
No power to the unit
RX
ON
PTZ control signals being
sent from PTZ control device
OFF
Normal conditions
TX
ON
PTZ control signals being
received from encoder
OFF
Normal conditions
Ethernet RJ45 Port Status LED
Each RJ45 Ethernet port has 2 indicators, a yellow
lamp & a green lamp. The yellow lamp indicates video
is streaming, the green lamp indicates port link state.
Link Status
(Green)
ON
Link connected
OFF
No connection
LINK/ACT
(Yellow)
FLASH Streaming video
Note:
A solid RX LED indicates a data wiring or
other data related error.
Dip Switch Default Configuration
RS485/422 RS232
1 to 4 - ON 1 to 4 - OFF
5 to 8 - OFF 5 to 8 - ON
PTZ Data Wiring Configuration
RS-485, 2 wire: PTZ control TX+ to decoder TX+
PTZ control TX- to decoder TX-
RS-422, 4 wire: PTZ control TX+/- to decoder TX+/-
PTZ control RX+/- to decoder RX +/-
RS-232: transmit to decoder TX+
receive to decoder RX+
ground to decoder GND
Contact Closure Default Configuration
ENC-A-W* Encoder Action
DEC-A-W* Decoder
D01 DO2 DI1 DI2
D01 D02 DI1 DI2
ON ON ON
ON
Normal state
OFF OFF ON
ON
OFF ON ON
ON
Short decoder DI1
to gnd
GND
ON OFF ON
ON
Short decoder DI2
to gnd
GND
GND
Short encoder DI1
to gnd
ON
OFF ON
ON
GND Short encoder DI2
to gnd
OFF ON
ON
ON
Note:
Triggers from default configurations shown. See
decoder interface settings to configure other trigger
options.
Need Help/Troubleshooting?
Visit our website
or
contact your nearest KBC office or dealer:
APAC:
Phone: +65 98463323
Email:
EMEA:
Phone: +44(0)1622 618787
Email:
USA:
Phone: +1 949-297-4930
Toll Free: +1 888-366-4276
Email:
Quick Start Guide
DEC-A-W*
Decoder
Decoder Status Indicators
QSG_Decoder_MPEG4-Rev1206A
Copyright © KBC Networks Ltd. 2012