Delta 50-866 - Manual (Page 8)

8
Fig. 15
Fig. 16
Fig. 17
Fig. 18
9. Fig. 15, illustrates both drums (K) assembled to the
fan and blower assembly (F).
ASSEMBLING DRUM
SUPPORT POSTS TO
BASE AND DRUMS
1. Assemble end of drum support post (A) Fig. 16, to
threaded holes in one corner of base (B). Place a 5/16"
lockwasher (C), on a 5/16-18 x 5/8" hex head screw (D),
insert the screw through the hole in the support post and
thread the screw into the hole in the base. Repeat this
process for the remaining hole. Assemble the remaining
three drum support posts to the base in the same
manner.
2. Assemble the top of drum support post (A) Fig. 17,
to drum (D). Place a 5/16" flat washer onto a 5/16-18 x
5/8" hex head screw, insert screw through the drum
support post and drum, and place a 5/16" lockwasher
onto the screw, and thread 5/16-18 nut onto screw and
tighten securely. Repeat this process for the remaining
hole. Assemble the remaining three drum support posts
to the drums in the same manner.
3. Fig. 18, illustrates the four drum support posts (A)
assembled to the base and drums.
K
K
F
A
B
D C
A
D
A
A