Delta 50-866 - Manual (Page 12)

12
Fig. 32
CONNECTING MACHINE
TO POWER SOURCE
MODEL 50-866
SINGLE PHASE
INSTALLATION
WARNING: Installation by a qualified electrician is
recommended to assure safe and proper wiring and
product operation.
The motor rating for your single phase dust collector is
230 Volts, 5 H.P. Before connecting your dust collector
to an electrical power system, be sure the electrical
system agrees with the motor rating of the tool.
The single phase Model 50-866 Dust Collector is
supplied with a motor and controller; however, it is not
furnished with a power cord or plug. To connect the dust
collector to a power system, proceed as follows:
1. Assemble the control box (A) Fig. 32, to the front of
the side support (H) Fig. 33. Insert sheet metal screws
(B) Fig. 32, through holes in the controller box and
thread the sheet metal screw into the side support and
tighten securely.
2. Bring the power cord (not supplied) up through the
large knockout hole (C) Fig. 32, in the control box (A) and
connect the two power lines to terminals (D) and the
green ground wire to ground screw (E). NOTE: THE
POWER CORD MUST BE INSERTED THROUGH THE
BUSHING IN THE ACCESS HOLE (C), TIGHTEN THE
ACCESS HOLE NUT OVER THE ACCESS HOLE TO
HOLD THE POWER CORD IN PLACE.
3. Reassemble the cover onto the controller box (A)
Fig. 33.
4. The ON/OFF buttons are located at the front of the
control box. To start the machine, push “ON” button (F)
Fig. 33. To stop the machine, push the “OFF” button (G).
Fig. 33
A
F
G
H
B
B
C
A
E
D
D