Delta 50-866 - Manual (Page 6)

6
ASSEMBLY
ASSEMBLING CASTERS TO
BASE
Turn base over. Align four holes in caster (A) Fig. 5, with
four holes at one corner of base (B) and assemble caster
to base. Place a 5/16" lockwasher (D), then a 5/16" flat
washer (E) on a 5/16-18x5/8" hex head screw (C), insert
the hex head screw through the hole in the wheel caster
and thread the screw into the base. Repeat this process
for the three remaining holes. Assemble the remaining five
casters (A) Fig. 6, to the underside of the base (B) in the
same manner.
Fig. 5
Fig. 6
Fig. 7
Fig. 9 Fig. 8
ASSEMBLING SUPPORTS,
MOTOR AND BLOWER
ASSEMBLY TO BASE
1. Turn base over so it is resting on the casters.
2. Assemble two supports (A) Fig. 7, to the threaded
holes at the sides of the base (B). Place a 5/16"
lockwasher (C) on a 5/16-18 x 5/8" hex head screw (D),
and insert the screw through the side support and
thread the screw into the base. Repeat this process for
the remaining screw. Attach the other side support in the
same manner. NOTE: Do not completely tighten
hardware at this time.
3. Assemble two cross-member supports (D) Fig. 8,
diagonally to the two side supports (A). Align the holes
in the cross-member supports (D) with the holes in the
side supports (A). Place a 5/16" flat washer (B) on a
5/16-18 x 5/8" hex head screw (C), insert the screw
through the cross-member support and side support,
and place a 5/16" lockwasher onto the screw and fasten
with a 5/16-18 hex nut (E). Repeat this process for the
remaining hole. Attach the other cross-member support
in the same manner. The cross-member supports (D)
Fig. 9, are shown assembled to the side supports.
NOTE: Tighten hardware at this time.
A
B
D
A
A
A
B
C D E
A
B
C
D
C
B
E
D