Delta 50-850 - Manual (Page 8)

8
Fig. 18
Fig. 19
Fig. 22
Fig. 20
Fig. 21
ASSEMBLING FILTER AND
DUST COLLECTION BAGS
TO DRUM
1. Hook the loop on the top of filter bag (A) Fig. 18,
onto filter bag support rod (B) as shown.
2. Assemble extension rod (C) Fig. 19, onto the end of
filter bag support rod (B). Raise support rods (B) and (C),
with filter bag (A) attached and place end of support rod
(C) into holes of bracket (D). NOTE: Flared end of filter
bag extension rod will prevent the rod from sliding through
bracket.
3. Position open end of filter bag (A) Fig. 19, over lip of
dust drum (E). Insert locking band (F) Fig. 20, through
the loops of filter bag (A) and fasten with clamp (G) as
shown in Fig. 21. NOTE: Make certain locking band is
positioned in the channel of drum (F) before fastening
clamp.
4. Pull up on each retaining clip (A) Fig. 22, and insert
the dust collection bag (B) underneath each retaining clip
to hold the dust collection bag in place.
5. Place the locking clamp (C) Fig. 22 around dust
collection bag and dust collector drum and lock in place.
NOTE: Make certain locking clamp is positioned in the
channel of the dust collector drum before locking clamp.
A
B
B
A
E
C
D
G
A
E
F
G
E
A
B
C