Junger Audio C8611 - Dolby® E encoder - Manual (Page 3)

digital audio
modular
processing system
C8000
Dolby
®
E encoder
C8611
3/13
installation
Set the CAN ADDR rotary encoder to an address, which is not in use by another module
of a C8000 frame (for details regarding CAN addressing, see C8000 system manual).
BUS-EN = OFF will disable the bus driver circuits on power up
SW-1B = ON enables the CAN “+16” address schema to handle up to 32 modules
SW-1C = not used
SW-1D = not used
Important Note! If the module has an unknown bus configuration, you must set BUS-EN=OFF, before
inserting the module into a C8000 frame. Otherwise you risk disturbing other channels of the frame.
Pressing the INIT button during power up will initialize the module parameters to factory default values.
status LEDs
STATUS green = OK
red = bad
flashing
green = under GUI control
VIDEO-REF green = frame rate matches the one selected for Dolby E encoding
Off = no Frame Reference available or frame rate of the reference
does not match the one selected for Dolby E encoding
DOLBY E blue = the encoder delivers a proper Dolby E signal
Off = Dolby E encoding error (see VIDEO-REF)