Ivie iFlex 2400 Series - Manual (Page 13)

Figure 10
will set the mixer to control the ‘Manual’ mode
level with the level control that has the same group
name. Set all the gold inputs in manual mode
to this same group designation, and they will all
follow the level control defined in our template.
You will want to complete the programming of the
other inputs, using the ‘Grand’ and ‘Silver’ group
names where appropriate.
Simulation
You have now completed the programming of the
iFlex mixer for the ballroom example. You may at
this point want to again compare the model to the
file “XXX”. You should now be ready to use the
simulation/debugging features in Sontata
TM .
Return to the layout screen by selecting the layout
tab in the lower-left corner of the screen. Now
select the ‘View, Run Mode’ option of the menu
bar in the upper-left corner of the screen. You
should now see something similar to figure 10
above.
If you see lines or grid points when you didn’t
want them, you can go back to the layout view
(‘View, Layout Mode’ from the menu bar), and
turn them off (‘View, Show Lines/Grid’). When
you return to the run mode (‘View, Run Mode’),
they should be gone.
Play around with the folding door switches to
watch your logic displayed. You can turn the
manual switch on, but remember that since the
‘Manual’ mode was placed on the input side of the
mix, no colored output zones will change.
You can also select any output zone, in any mode,
and look at the processing elements associated
with that zone in that mode. The processing
elements for the selected zone are displayed in the