D-Link DES-818 - Manual (Page 25)

10/100 Fast Ethernet Switch User’s Guide
Installation
15
Connecting Power
Power is supplied to the 10/100 Fast Ethernet Switch through an AC power
cord. The AC power input voltage ranges from 100 to 240 VAC. A power
cable is included with the device.
Figure 5 Connecting Power
Network Connections
If any port on the 10/100 Fast Ethernet Switch is set for full-duplex
operation, the device (or LAN) connected to that port should also be set for
full-duplex operation. The following sections discuss the requirements for
each operating mode.
10/100Mbps Ports
These ports (1 and 2 on both models) require Category 5 unshielded twisted-
pair or shielded twisted-pair (UTP/STP) cable to run at 100Mbps. The
attached station must be within 100 meters of the 10/100 Fast Ethernet