ILUMINARC Ilumiline™ 36 IP - Manual (Page 6)

Ilumiline 36 IP Optic RGB QRG
6
DMX
Connection
You can connect the bare-ended IP67 rated signal cable from the product to
two IP67 rated signal connectors (DMX in and DMX Out) or use an IP67
rated junction box. If using an IP67 rated junction box, make sure to use
IP67 rated conduit.
Signal Wiring
To provide a signal for this product, you can connect the bare-ended IP67
rated signal cable from the product to two IP67 rated signal connectors
(DMX in and DMX out) or use an IP67 rated junction box. In this case,
make sure to use IP67 rates conduit.
The signal cable must match or exceed the electrical characteristics of
the Belden® 9841 cable for EIA RS-485 applications. You can also use
CAT 5, CAT 5e, or CAT 6.
DMX Junction Box
Wiring
DMX Cable Table Connection DMX In DMX Out IP67 Pin
Ground Shield Shield 1
Data - Black Green 2
Data + White Red 3