Holland Electronics HPH860 - Manual (Page 5)

5
Installation Procedure
1. Connect the I.F. jumper from the I.F. output to the
I.F. input on the HPH-860 rear panel.
2. Insert power plug into a surge protected 90 - 260
VAC outlet. Observe the lit POWER LED light
indicating power is on.
3. Connect a spectrum analyzer or field strength
meter to the processor RF OUT port.
4. Connect RF signal source to RF IN port. Signal
level should be ~5 – 25 dBmV.
5. Set the HPH-860 desired input channel Mode and
Number. (see page 4)
6. Set the HPH-860 desired output channel Mode
and Number. (see page 4)
7. Turn the OUTPUT LEVEL adjustment on the front
panel of the processor to get the desired output
level.
8. Turn the AURAL CARRIER adjustment to set the
audio carrier 12 - 17 dB below the video carrier.
9. Remove the analyzer or field strength meter from
the processor RF OUT port.
10. Connect the processor RF OUT port to a
television/monitor. (Make sure to use the proper
size attenuator between the processor and the
television/monitor in order to avoid overdriving the
television/monitor.)
11. Verify that the television/monitor picture is of good
quality for viewing.
12. Remove the television/monitor and attenuator
from the processor RF OUT port.
13. Connect the processor RF OUT port to the RF
input of the head-end system.