Future Automation LA - Manual (Page 6)

Detail C
Strut Bolt
Link Bars
When you take the machanism down for the first
time with the lid on, be prepared to press stop
if it goes down to far. It should ideally stop short
of hitting the safety edge by about 2mm.
Adjusting the length of the strut bar will adjust how
horizontal the lid will be in the down position. Adjust
this first.
To change the height of the lid in relationship to the
box, adjust the two link bars equally, or lift the
mechanism up on shims. In the down position line
up the lid with the box by moving the mechanism.
Then fix in place.
Screen cables are run through the arm. Remove
the cover plates to gain access through the
joint.
Finally fit the Top Trim using magnetic catches or
similar.
Top Trim
Screen Cables go in
here on both sides
Cables come
out here.
C
2 to 3mm
Stage 4
Setting Up
Sheet 6 of 8
ISSUE: 001
www.futureautomation.co.uk
FUTUREAUTOMATION
LA - Lifting Arm
Instructions