Future Automation PLS - Manual (Page 7)

In
st
all
at
io
n
: S
ta
ge
2
Page 6 of 22 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
PLS - Plasma Lift and Swivel
Fitting Flap Panel to the Mechanism
The 6mm flap and the base should be
made as part of the cabinet. The surfaces
of the flap should ideally be varnished or
painted to help prevent it from warping.
Take care when fixing the surfaces together.
Place the objects on a flat surface to make
sure the edges are properly aligned when
they come into contact.
Try to use as many self adhesive pads as
possible to get the most secure fixture.
Aluminium Flap
Adhesive
Pad
Flap
One large hole to be drilled in base panel. This hole should be 86mm diameter to allow
for adjustment later. The hole's centre has to be 102.5mm away from the front edge of
the base panel. Depth of base panel depends on mechanism size, e.g. 275 or 320.
86
10
2.
5