Future Automation PLS - Manual (Page 11)

In
st
all
at
io
n
: S
ta
ge
6
Page 10 of 22 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
PLS - Plasma Lift and Swivel
Adjusting the Flap Up Position
CABINET TOP - SIDE VIEW
By adjusting the white screw, at each side
of the lift, you can adjust the tilt of the flap.
CABINET TOP - PLAN VIEW
By loosening the M6 bolts on each side under the
flap, you can adjust the position of the flap in the
hole in the cabinet top. Aim for a 3mm gap all round.
CABINET TOP - SIDE VIEW
By winding the push rods on each side, you
can adjust the height of the flap in order to
get it level with the cabinet top. Be sure to
lock the nut securely once adjusted. Make
sure the black plate doesn't touch the inside
of the cabinet. This can cause strain on the
motor, leading to failure.