Future Automation PLS - Manual (Page 10)

In
st
al
la
ti
o
n
:
S
ta
ge
5
Page 9 of 22 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
PLS - Plasma Lift and Swivel
Positioning the Base Panel
Loosen off the frame and move the base to the
centre of the opening.There should be a gap of
about 3mm around the edges of the base panel
to the cabinet.
Pass the cables up through the swivel unit
and base to the screen.
Secure the base in place from the underside
through the two fixing brackets.
Fixing
Brackets
Once the base panel has been positioned correctly and properly secured, it
is then possible to re-attach the mounting frame. Firstly make sure the
mechanism is in the 'Home' position. Then the screen mounting frame can
be bolted down. Make sure the mounting frame is square with the slot in the
cabinet.
Consult PLS TECHNICAL SHEET before
fabricating any flaps or base panels.
Base
Remove the screen mount from the
mechanism and put the base on the
beam. With the base panel on the beam,
it will be possible to mark where the
wood screws will need to go through the
support plates into the base panel. Mark
where the holes need to go and then drill
a pilot hole for the screws. Then screw in
the provided wood screws with washers.