Future Automation LSL-PF - Manual (Page 9)

In
st
all
at
io
n
: S
ta
ge
4
Page 8 of 18 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
LSL PF - Lift System Light Push Flap
Mounting the Base Panel
After the mechanism is in the
correct position the next step
is to lower the BASE PANEL
into place and fix from the
underside through the BASE
PANEL BRACKETS. A good
tip is to place the BASE
PANEL in place and draw
marks from the underside
through the BASE PANEL
BRACKETS, then fix using a
wood screw and a large
penny washer, this will allow
you to adjust the position.
BASE
PANEL
BASE PANEL
BRACKETS
FLAP
Page 12
Stage 8 - Details
on adjusting the
OUT position