Future Automation LSM-TU-EFA - Manual (Page 8)

In
st
al
la
ti
o
n
:
S
ta
ge
3
Page 7 of 18 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
LSM TU EFA -
Lift System Medium Telescopic Unit Electric Flap Actuator
Mounting the Base Panel and Flap
After the mechanism is in the correct position the next step is to lower the BASE PANEL
into place and fix from the underside through the BASE PANEL BRACKETS. A good tip
is to place the BASE PANEL in place and draw marks from the underside through the
BASE PANEL BRACKETS, then fix using a wood screw and a large penny washer, this
will allow you to adjust the position.
BASE
PANEL
BASE PANEL
BRACKETS
FLAP
Page 11
Stage 7 - Details
on adjusting the
OUT position