Doremi DCP-2000 - Manual (Page 18)

(a) (b)
Figure 18: 2U Fan Shock Mounts Visual Inspection – Correct Installation
Caution: Do NOT take out the fans from the shock mounts. Do a visual inspection only.
If the shock mounts are not properly attached, use your fingers to fix them as illustrated below:
Figure 19: 2U Fan Shock Mounts Re-Attachment Example
If the shock mounts need to be replaced, please contact Doremi (Section 1.2) for additional guidance.
5.1.4 Noise from Fans and Rattling
In a secure location, power on the unit with the lid off.
Listen to see if there is any noise coming from fans.
If such noise is coming from a fan, remove power to fan by unplugging the noisy fan connector. When
the connector corresponding to the noisy fan is removed, the noise should stop.
Then replace that fan with a fan having the same Part Number. Contact your local Doremi Support
team (Section 1.2) for fan replacement and for additional guidance.
D2K.DP.000255.DRM Page 18 of 24 Version 1.8
Doremi Labs
Pull gently on the
shock mounts with
your fingers
Shock
Mounts
Fans
parallel to
unit