Draytek Vigor 2800 - Manual (Page 11)

5
1.3 Front Panel LEDs and Rear Panel Interfaces
1.3.1 Vigor2800Gi
LED Status Explanation
ACT (Activity) blinking The router is powered on and running properly.
on The ISDN network is correctly setup. ISDN
blinking A successful remote connection on the ISDN BRI B1/B2
channel.
on The P2P function is active P2P
blinking When starting to prohibit P2P data
on
The DoS function is enabled. Firewall
blinking When encountered DoS attacks.
on
The wireless LAN function is enabled. WLAN
blinking Ethernet packets are transmitting over wireless LAN.
DSL on The ADSL,ADSL2/2+ line is showtime.
Printer on The USB interface printer is ready.
orange A normal 10Mbps connection is through its corresponding
port.
green A normal 100Mbps connection is through its corresponding
port.
LAN
(P1, P2, P3,
P4)
blinking Ethernet packets are transmitting.
Interface Description
Printer Connect to the USB printer.
PWR Connect the included power adapter to the power outlet.
P1, P2, P3, P4 Connect to the local networked devices.
DSL Connect the ADSL,ADSL2/2+ line to access the Internet.
ISDN Connect to the NT1 (or NT1+) box provided by ISDN service provider.
Factory Reset Restore the default settings.
Usage: Turn on the router (ACT LED is blinking), press the hole and
keep for more than 5 seconds. When the ACT LED begins to blink
rapidly, release the button. Then the router will restart with the factory
default configuration.