Doremi DCP-2000 - Manual (Page 7)

4 Calibration
You need to install the packages provided by Doremi for the calibration. Follow the steps below:
1. Plug in the USB stick containing the Dolby3D calibration material.
2. An Ingest window will appear, showing the content on the USB stick.
3. Ingest the package titled, “Dolby3D Calibration Material.”
Then run the wizard according to the procedure below:
1. Open a terminal (go to “Menu->System->Terminal”)
2. Run the command “/doremi/bin/dfc100setup.sh”
The wizard window will appear as illustrated in the section below. Follow the wizard’s steps.
4.1 Wizard - First Step
The first step is just a reminder of the configuration of the DFC100 described above – see Section
3.
Figure 4: Wizard Window - First Step
• Click on Next to go to the second wizard step.
D2K.DP.000462.DRM Page 7 Version 1.4
Doremi Cinema LLC Confidential