Doremi DCP-2000 - Manual (Page 5)

2.1.2 DCP-2000 Analog (ANA) Audio Connector - Optional
The DCP-2000 analog un-balanced audio output connector pin-out follows:
2.2 Doremi AUD-D2A - Audio Converter
The AUD-D2A is an 8 channels digital to analog audio converter that can be connected between
the DCP-2000 digital audio output and an analog audio input of analog audio processor.
Its audio I/Os are located on the rear panel as presented below:
Figure 3: AUD-D2A Rear Panel
Note: The AUD-2A has the same analog output wiring scheme as the internal DCP-2000 analog
audio output (which is optional in the DCP-2000).
D2K.OM.000663.DRM Page 5 Version 1.2
Doremi Cinema LLC
Pin # Signal Description Pin # Signal Description
1 Ch 8 plus 14 no connection
2 Ch 8 ground 15 Ch 7 plus
3 no connection 16 Ch 7 ground
4 Ch 6 plus 17 no connection
5 Ch 6 ground 18 Ch 5 plus
6 no connection 19 Ch 5 ground
7 Ch 4 plus 20 no connection
8 Ch 4 ground 21 Ch 3 plus
9 no connection 22 Ch 3 ground
10 Ch 2 plus 23 no connection
11 Ch 2 ground 24 Ch 1 plus
12 no connection 25 Ch 1 ground
13 no connection
Analog Audio Output Digital Audio Input
DCI Channel Map:
Channel 1: L (screen, left)
Channel 2: R (screen, right)
Channel 3: C (screen, center)
Channel 4: LFE (screen, low frequency
effects subwoofer)
Channel 5: Ls (surround, left wall)
Channel 6: Rs (surround, right wall)
Channel 7: Lc (screen, mid left to
center)
Channel 8: Rc (screen, mid right to
center)
Pin 1
Pin 25
Pin 2
Pin 13
Pin 14