Doremi CaptiView - Manual (Page 9)

4 Annex A: Logging into CaptiLink
4.1 Logging into CaptiLink via SSH
• The default IP address of the CaptiLink is 192.168.9.10.
• Set your computer's IP address in the range '192.168.9.xx', xx being in the range (2-254
except 10 when using default IP).
• Connect the CaptiLink with an Ethernet cable to the newly configured port and power
ON.
• Download and install the program "PuTTY" (or any ssh client) on the computer you just
assigned the new IP address to.
• Connect to the default IP 192.168.9.10 on port 22 using the ssh client.
Note: If the IP address was changed using the USB method, use the IP address that was
assigned to the CaptiLink instead of the default IP.
• When the unit is done booting up, log in as "root."
◦
Password for "root:" "veeone."
◦ It is recommended to change the "root" password by typing the following command
and following the on-screen instructions: "passwd"
4.2 Logging into CaptiLink via Serial Port
• The serial cable required for a proper connection is a female-to-female, pin-to-pin cable,
which is provided in the package.
◦
Serial connection settings are:
▪
Speed 115200
▪ Data bits: 8
▪ Stop bits: 1
▪ Parity: None
▪ Flow control: None
◦ Connect and switch the device on and wait for it to boot.
• When the unit is done booting up, log in as "root."
◦
Password for "root" is “veeone”
It is recommended to change the root password by doing the command and following the on-
screen instructions: "passwd"
CTL.OM.002498.DRM Page 9 Version 1.0
Doremi Cinema LLC