Doremi CaptiView - Manual (Page 8)

3.1.2 Configuring the Network via CLI
Note: This method is valid for all CaptiLink software versions. For more information on logging
into the Command Line Interface (CLI), see Section 4.
3.1.2.1 IP Configuration
• To configure the IP of the CaptiLink, type the following command (xxx.xxx.xxx.xxx = the
desired IP address):
echo -n xxx.xxx.xxx.xxx > /doremi/etc/ip_addr
• To configure the netmask, type the following command:
echo -n xxx.xxx.xxx.xxx > /doremi/etc/netmask
• To configure the gateway, type the following command:
echo -n xxx.xxx.xxx.xxx > /doremi/etc/gateway
3.1.2.2 NTP Servers (Optional)
• To add a new line to your NTP setup, type the following command while replacing the
bold item with your desired NTP settings:
echo NTPSERVERS="server_1" >> /doremi/etc/ntpservers
3.1.2.3 DNS (Required for NTP)
• To add a new line to your DNS, type the following command:
echo “nameserver 172.17.16.1” >> /doremi/etc/resolv.conf
3.2 Configuring the Transmitter's Auditorium Number
Note: This is the only method valid for all CaptiLink software versions. For more information on
logging into the Command Line Interface (CLI), see Section 4.
• To change the auditorium of the CaptiView Transmitter, replace the bold item with a
number that is in the range of 1-32. Make sure that no two transmitters are configured
with the same auditorium number:
echo -n aud_number > /doremi/etc/s430-10/audi.conf
• Reboot for the changes to take effect.
3.3 Adding the IP of the Digital Cinema Server to the CaptiLink
Note: This is the only method valid for all CaptiLink software versions. For more information on
logging into the Command Line Interface (CLI), see Section 4.
• To add the IP address, type the following command:
echo -n xxx.xxx.xxx.xxx > /doremi/etc/s430-10/ip.conf
• Reboot the CaptiLink for the changes to take effect.
CTL.OM.002498.DRM Page 8 Version 1.0
Doremi Cinema LLC