d&b Z5375 T Base plate - Manual (Page 7)

5. Set the desired splay angle
- On the rear, set the splay angles between the cabinets as follows:
- Preset the desired splay angle on the top cabinet by
inserting one Locking pin.
- Fold up the Splay link of the cabinet below into the rear
rigging strand of the upper cabinet.
- Lift the upper cabinet by hand until the hook of the Splay
link has hooked into the preset Locking pin.
- Insert the second Locking pin (safety pin) to secure the Splay
link.
5. Maintenance and care
Storing/transport
The surface treatment temporarily protects the Base plate against
moisture. However, ensure the Base plate is in a dry state when storing
and transporting it.
During transport ensure the Base plate is not stressed or damaged by
mechanical forces. Use suitable transport cases.
Cleaning
Regularly clean and lubricate the Base plate using WD-40 ® or a similar
product.
Inspections
To eliminate the potential risk of accident due to malfunctioning of the
Base plate, regularly carry out a visual and functional inspection.
If the Base plate fails to operate correctly and/or safely, it must be
withdrawn from use immediately.
Carry out a visual inspection of the Base plate for obvious deformation
and damage (e.g. cracks and corrosion).
6. Disposal
Please dispose of this product according to the respective national
regulations.
Ensure that damaged rigging components are disposed of so that they
cannot be used again.
Z5375 Mounting instructions (1.1 EN) Page 7 of 8