d&b xA-Series - Manual (Page 16)

Dual pickpoint operation
With dual pickpoint operation the overall vertical aiming of the
entire array is set by trimming the hoist motors after the array has
been fully assembled and lifted to its operating position.
3.1.2. Additional suspension options
In addition to the standard suspension option using the Flying bar
xA together with the Flying bar adapter xA, vertical arrays can be
suspended using one of the following options.
Note: All these options require a second pickpoint acting as
a pullback anchor device to set the overall vertical aiming of
the entire array. This second pickpoint is attached in the lower
part of the array between adjacent cabinets or at the end of
the entire array. Refer to .
Option 1: Suspension of the array using the Z5414 Flying bar
xA together with 2 x 1t shackle, e.g. d&b E6507.
Option 2: Suspension of the array using the Z5419 Load bar
xA together with 2 x Z5420 Load eye bolt.
Option 3: Suspension of the array using the Z5419 Load bar
xA together with 2 x 1t shackle, e.g. d&b E6507.
Option 4: Suspension of the array using the Z5419 Load bar
xA together with 2 x Z5420 Load eye bolt.
d&b xA-Series, Rigging manual (1.1 EN) 16