Ack nak retry count -22, Rs-232 interface features — cont – Datalogic Scanning 1000I User Manual

Page 48

Text mode
Original mode

Interface Related Features

3-22

Magellan

1000i

RS-232 Interface Features — cont.

ACK NAK Retry Count

START / END

PROGRAMMING BARCODES

This feature sets the number of times for the scanner to retry a label transmission under a retry condition.
000 = No retry
001 - 254 = Retry for the specified number of times
255 = Retry forever
To configure this feature, scan the “START/END” barcode above to place the unit in Programming Mode, then the “Set ACK NAK
Retry Count,” followed by the three digits (zero padded) from the Alphanumeric table in

Appendix C, Alpha-Numeric Pad

repre-

senting your desired retry count. Exit programming mode by again scanning the “START/END” barcode above

DEFAULT SETTING FOR THIS FEATURE: 003

Set ACK NAK Timeout Value