d&b T-SUB - Manual (Page 4)

T-SUB
Fig. 1: T-SUB loudspeaker
The T-SUB is the subwoofer for the T-Series. It can be used to
supplement T10 cabinets in various combinations, either flown or
ground stacked. The T-SUB cabinet is an actively driven bass-reflex
design housing a long excursion 15" driver, its frequency response
extending from 47 Hz to 140 Hz.
The T-SUB cabinet is constructed from marine plywood and has an
impact and weather resistant black paint finish. The front of the
loudspeaker cabinet is protected by a rigid metal grill in front of an
acoustically transparent foam. The cabinet top panel incorporates a
handle.
NOTICE: Only operate T-SUB loudspeakers with a correctly configured d&b
amplifier, otherwise there is a risk of damaging the loudspeaker
components.
T-Series rigging components and arrays
Cabinets are mechanically connected using the rigging strands on both
sides of the cabinet front and a central strand at the rear of the cabinet.
All necessary rigging components are mounted to the cabinet and are
folded or slide out when needed.
A detailed description of the T-Series rigging components is given in the
T-Series Rigging manual which is provided with the Z5370 T Flying
frame.
A detailed description of planning and designing T-Series arrays is
given in the technical information "TI 385 J-, Q- and T-Series system
design, d&b ArrayCalc" which is also provided with the T Flying frame.
The d&b ArrayCalc array calculator can be downloaded from the d&b
website at
www.dbaudio.com .
T-SUB Manual (1.0 EN) Page 4 of 8