Mowing tips, Operation – Dixon Kodiak SE 5225 KOH CE User Manual
Page 31
Mowing Tips
Observe and flag rocks and other fixed
•
objects to avoid collisions.
Begin with a high cutting height and reduce it
•
until the desired mowing result is attained.
The average lawn should be cut to 2½"
(64 mm) during the cool season and over
3" (76 mm) during the hot months. for
healthier and better looking lawns, mow
often after moderate growth. for best cutting
performance, grass over 6" (15 cm) in height
should be mowed twice. make the first cut
relatively high, the second to the desired
height.
The mowing result will be best with a high
•
engine speed (the blades rotate rapidly) and
low speed (the rider moves slowly). If the
grass is not too long and dense, the driving
speed can be increased without negatively
affecting the mowing result.
The finest lawns are obtained by mowing
•
often. The lawn becomes more even and the
grass clippings more evenly distributed over
the mown area. The total time taken is not
increased as a higher operating speed can
be used without poor mowing results.
Avoid mowing wet lawns. The mowing result
•
is poorer because the wheels sink into the soft
lawn, clumps build, and the grass clippings
fasten under the cowling.
Hose the mower deck underside with water
•
after each use. When cleaning, the mower
deck shall be raised into the transport
position. make sure the mower is cooled and
the engine is off.
Use compressed air to clean top surface of
•
the deck. Avoid flooding water on top surface,
engine and electrical components.
When the mulching kit is used, it is important
•
that the mowing interval is frequent.
WARNING!
Clear the lawn of stones and other
objects that can be thrown out by the
blades.
8011-603
Mowing pattern
WARNING!
Never drive the rider on terrain that
slopes more than 10 degrees. Mow
slopes up and down, never side
to side. Avoid sudden directional
changes.
opeRatIon
31