Dimplex Purifire BF series - Manual (Page 10)

7
To access the light bulb area
1. Open steel curtain (remove glass doors if
applicable).
2. Remove two screws on log bracket and set
aside. (FIGURE 4)
3. Pull front edge of plastic ember bed or plastic
grate up and forward until rear tab releases
from the ledge located at the bottom of the
mirror. (FIGURE 5)
Note: Log set fits tightly into firebox, some force
may be necessary to remove.
4. Set logset in front of firebox.
5. Disconnect the logset LED wire harness from
unit. (FIGURE 6)
6. Examine the bulbs to determine which bulbs
require replacement.
7. Unscrew bulbs counter clockwise.
8. Insert new bulbs.
9. Re-connect the logset LED wire harness to the
unit.
10. Replace the log by inserting the rear tab of the
logset under the back ledge of the fireplace
and push down on the front edge of the logset
until it snaps into place. (FIGURE 5)
11. Replace log grate using two screws previously
removed.
SCREWS
FIGURE 5
FIGURE 4
FIGURE 6