COMMELL LS-373 User Manual

Page 24

Text mode
Original mode

LS-373 User’s Manual

To setup the LCD, you need the component below:
1. A panel with LVDS interfaces.
2. An inverter for panel’s backlight power.
3. A LCD cable and an inverter cable.

For the cables, please follow the pin assignment of the connector to make a cable,

because every panel has its own pin assignment, so we do not provide a standard cable;

please find a local cable manufacture to make cables.

LCD Installation Guide:

1. Preparing the LS-373, LCD panel and the backlight inverter.

2. Please check the datasheet of the panel to see the voltage of the panel,

and set the jumper JVLCD to +12V or +5V or +3.3V.

3. You would need a LVDS type cable.

4. To connect all of the devices well.

For sample illustrator only

Panel side

Board side