Dacor MCS130 - Manual (Page 9)

7
Before attempting to connect the appliance to power, turn off the
electrical power supply. Also, always turn off electrical power to
the appliance prior to servicing it.
The appliance must be connected to the power supply with copper
wire only. The use of aluminum wire may result in unsatisfactory
connections. Flexible armored or non-metallic, sheathed copper
cable (with grounding wire) should be used to connect the
appliance to the junction box. A UL-listed connector must be used
to directly connect the cable to the junction box.
Be certain to locate the junction box such that the electrical supply
may be easily disconnected in the event that service becomes
necessary. Also, provide extra slack in the cable to allow the oven
to slide forward for servicing.
This appliance must be electrically grounded.
With the oven positioned directly in front of the cabinet cutout,
feed the appliance conduit to the electrical junction box.
Then, depending upon local codes, utilize one of the following
techniques to connect the appliance to the electrical power
supply:
T
uRning
o
ff The
p
oweR
s
upply
e
leCTRiCal
C
onneCTion
WARNING
WARNING – Failure to disconnect power may result in
electrical shock or fire hazard.
WARNING
1. This appliance must be connected to a grounded,
metallic, permanent wiring system. Alternatively, a
grounding conductor should be connected to the
grounding terminal or lead on the appliance. Failure to
do so may result in an electrical shock hazard.
2. Do not install a fuse in the neutral or ground circuit. A
fuse in the neutral or ground circuit may result in an
electrical shock hazard.
g
Rounding
i
nsTRuCTions
i
nsTallaTion
i
nsTRuCTions
A. Connecting to a Four-Wire Electrical System
1. Separate the green and white appliance wires.
2. Connect the white appliance wire to the neutral (white) supply wire in
the junction box.
3. Connect the black appliance wire to the black (L1) power supply wire
in the junction box.
4. Connect the red appliance wire to the red (L2) power supply wire in
the junction box.
5. Connect the green appliance wire to the green house grounding wire
Conduit from
appliance
Cable from
power supply
Wire nut
(4 places)
Junction
box
RED
RED
GREEN
GREEN
WHITE
WHITE
BLACK
BLACK
Connecting the Appliance to a Four-Wire Power Supply
WARNING
WARNING – Do not connect the green appliance wire to
the neutral (white) junction box wire unless local building
codes permit.
Conduit from
appliance
Cable from
power supply
Wire nut
(3 places)
Junction
box
RED
RED
GREEN
WHITE
WHITE
BLACK
BLACK
Connecting the Appliance Ground to Supply Neutral
B. Connecting the Green Appliance Wire to the Neutral
(White) Supply Wire – Where Local Codes Permit
1. Connect the green and white appliance wires to the neutral (white)
supply wire in the junction box.
2. Connect the black appliance wire to the black (L1) power supply wire
in the junction box.
3. Connect the red appliance wire to the black (L2) power supply wire in
the junction box.