Brennenstuhl CO Detector BCN 1221 - Manual (Page 26)

The CO-detector should be installed by a
professional.
After the battery has been installed, the green
LED “POWER” will blink 1x green once for indica-
tion. Wait about 1 minute until the detector has set
itself up. Then test the detector by pressing the
“test and hush” button and holding it until you
hear a series of 4 peeps. The red LED “ALARM”
will blink. Release the button and the siren will fall
silent immediately.
Inspect and test the detector after installation.
Make sure that you can clearly hear the alarm in
your sleeping quarters.
26
Operating Instructions BCN 1221
043909 CO-Melder BCN 1221-0 14.01.15 21:03 Seite 26