Brennenstuhl Eco-Line extension socket energy meter EM 235 5-way white 1,5m H05VV-F 3G1.5 - Manual (Page 28)

28 GB
Prior to Initial Use / Initial Operation / Operation
10. Press the SET-Button 4 to confirm your entry. The hundredths place after the comma
will blink.
11. Press the UP-Button 5 until you reach the desired value.
Example: 15,99
12. Press the SET-Button 4 , to confirm your entry.
Note: As soon as the overload value you entered is exceeded by one of the electrical
devices connected, the
OVER LOAD WARNING indicator will blink. The button’s
functions are deactivated.
i
Unplug the electrical device from the power strip and if necessary re-set the over-
load warning value.
Q
Initial Operation
q
Putting the Power Strip into Service
i Plug the power strip’s mains plug into a correctly installed electrical outlet.
i The LC-display 2 shows the time ( CLOCK), day of the week, current voltage
( VOLTac) as well as the current line frequency (Hz). This display combination is
the standard display.
i Now you can plug the desired electrical devices into the sockets 1 .
Q
Operation
CAUTION! POTENTIALLY FATAL DANGER OF ELECTRICAL SHOCK!
Only perform measurements at voltages of over 25 V~ in compliance with the relevant
safety regulations for the attached electrical devices.
CAUTION! DANGER OF INJURY! Never exceed the maximum prescribed
input voltage.
Note: The power factor shows how high the ratio between the real output and apparent
output of an electrical device. The power factor can lie between 0 and 100. In the
ideal case, the power factor will be equal to100.
Note: You can still access the following functions when the power strip is no longer
Steckdosenleiste_Content_DE_GB_NL_SE_ES.indd 28 23.07.14 13:23